You need to try the lipo charge menu selection that says Fast Charge or Charge, if the charger has this option. It doesn't appear the Tenergy unit is experiencing too low of an input current. I'm uncertain of the exact input current, the initial12 vdc supply voltage is from AC/DC converter, part of a 12 VDC electrical system. No problems have occured while in a 1S or 2S configuration.ĭoes this indicate a problem with the TB6S+ charger? The input voltage is approx. The connection break error occurs no matter which slots are used. A jumper wire is used for 1S, 2S and 3S configurations) The battery pack holder was tested for continuity and correct voltages after installing batteries. wire, plus a XT60 male plug for connection the TB6S+. (pos/neg leads were replaced with larger ga. This is not a balance port connected battery pack, but a 4 slot 18650 battery carrier, connected only to the charger's main pos+/neg+ leads. The connection break error message occurs under different LiPo modes - Auto, Balance charge, Fast charging, Storage mode & Discharge. when all installed batteries are at ~3.7 volts and when all batteries installed are at ~4 volts.ġS and 2S configurations charging is ok, however when as a 3S and 4S battery pack, after the initial "battery check" an error message is displayed "Connection Break". (without balancing port wire connections) Different 18650 batteries and combinations were tested, e.g. The problem I'm experiencing, when charging lithium 18650 batteries, I'm unable to charge a 3S and 4S configuration from the main pos+ / neg- circuits. I have a Tenergy TB6S+, small version of the TB6B.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |